Estas en: Inicio > Reguladores > Recambios
Descripción y características de Apeks Convertor Estribo a Din
Apeks Convertor Estribo a Din:
Kit de conversión de reguladores INT a DIN 300 bar.
La instalación de esta pieza la debe realizar un técnico cualificado por la marca y con herramientas específicas.
Productos comprados junto a Apeks Convertor Estribo a Din
Productos similares a Apeks Convertor Estribo a Din
OPINIONES
Easy to install!
Ben
Bought one of these to convert my DST - all you need is an adjustable wrench (shifting spanner) and a 6mm hex key. Only takes a couple of minutes to do. Use the adjustable wrench on remove the existing yoke fitting (you'll need a large wrench to get a good grip on the yoke bolt - the one with the little white filter in the middle), make sure you've got the o-ring holding the little wire filter in place in the new DIN converter, and screw it in using the hex key! Throw the yoke connector aqnd the hex key into your save-a-dive kit for those days when DIN tanks aren't available.
Yoke to din conversion
Fred
Be careful when removing the yoke retainer bolt from the regulator body. It can be rather tight. I would recomend using a 6 point 3/4" SAE box wrench on the yoke retainer bolt, making sure the wrench is seated well before applying pressure. The metal is somewhat soft, so an improperly applied wrench could round off the edges. The O ring may or may not come out with the bolt. If not, pluck it out before applying the DIN retainer. The DIN installation is simple, simply thread it into the body and tighten it with a 6 mm hex wrench. You can keep the yoke/bolt assembly in your dive kit if you need to convert back, but I carry several converter yokes with me which I find more convinient.
Very easy!
Jaysee
This DIN adaptor installed in 2 minutes!!! The hardest part was breaking the 19mm nut loose! then unscrew the yoke connection, screw in the DIN adaptor tighten with 6mm hex wrench and you are DONE!!! 300 Bar Adaptor fits 232 bar valves fine.... I did this whole job for less than what the DIN adaptor would cost me from my local dive shop!!!! I love this place!!
Facile
Olivier
Effectivement la modification est très facile: Déblocage de lécrou détrier avec une clé à mollette ou anglaise. Montage express du convertisseur DIN et serrage avec clé mâle de 6mm. Attention à ne pas oubler le joint de étrier au fond du détendeur.Ce kit convient au 1er étage sunnto teno (Apeks100)
COMPRAR POR
Categorías
Marcas
